There are very few limits on survey design and nearly all imaginable electrode configurations above and below ground can be inverted, including all traditional and well-known survey configurations. Worried that your data format is not supported and needs to be manually formatted for import? Unlike competitor products, Res2DInv and Res3DInv supports most industry data formats and supports virtually all sensors & instruments. The software is highly optimized for speed to enable easy and fast handling of small and medium sized surveys allowing initial in-field inversions for surveying efficiency.

You wouldn’t need a programmer or operator, and you will more then likely have it machine loaded.Experience a simple workflow from data import to inversion and visualisation, while still having access to full control over inversion parameters for those more experienced. Thanks all!If I worked there I think I would be looking for a new job. You will still have to peruse for the IGES file, but it will eliminate the Pcdmis menu-hunt. HOWEVER, you CAN make custom tool bars and instead of FILE~IMPORT~IGES you can simply click on the import iges icon in the tool bar. As for auto-import, 'I don't think Tim' (tool time). Thanks all!Well, if your 'master' program is set as READ ONLY, then they can only QUIT or save as, if they try to close, it prompts to do a save-as. Not sure if this is really possible, but it would save me a lot of time going through our current procedure (step-by-step) to find out where the operator went wrong. Ideally, I'd like the program to prompt the operator to do a save-as, automatically import the information, convert the xyz to surface points, and pretty much do everything the operator normally has to do. I'm just looking for a way to save some time and redundancy.

Would it be possible to use the file name as a variable to import the necessary geometry? Basically I open the default program and the first thing I do is save it as N10XXX-XXXX-EXX. We have a default program that we use for checking electrodes and a very stringent file naming structure for all our jobs. I was wondering if it would be possible to have PCD automatically import an IGES and XYZ file without having to go through the menus.

Import xyz to res2dinv